Bob's Knobs for C11 f/10 with Flat Secondary Housing (non-Fastar) and Metric Collimation Screw Threads
| Article number: | C11metBO |
| Availability: | In stock |
| Delivery time: | In Stock |
Knobs for C11 f/10 with Flat Secondary Housing (non-Fastar) and Metric Collimation Screw Threads
Part: C11metBO (black oxide steel); C11metSS (stainless steel)
Fits: Celestron 11” (28 cm) f/10 SCT versions with flat secondary housing and metric collimation screw threads (most CPC 1100).
Knobs: Black oxide steel (black) or stainless steel (silver), 12 mm (1/2”) diameter
Threads: Black oxide or stainless steel
Notes:
- Black Phillips factory collimation screws usually have metric threads, but some black Phillips screws have standard threads. Our hints will help you determine which screws are on your telescope. Make sure the knob threads match the factory screw threads before installing the knobs.
- Black oxide steel (shown in photo) is for dry environments. Lightly oil the knobs periodically as an anti-corrosion measure. Stainless steel provides better corrosion protection in coastal or high humidity areas, or in places where dew or other condensation is common.
- The factory dust cover will fit normally with Bob's Knobs installed.
- If your telescope has a factory-installed plastic cap over the collimation screws, it must be removed and set aside when Bob's Knobs are installed. The cover is cosmetic only and will not affect operation of the scope.